Spray valve | SAN-EI TECH LTD

line up

	Weight/Size	接続	Wetted parts material	maximum hydraulic pressure	For flow rate adjustment Stroke Adjustment mechanism
SV91	294g φ26.9×105mm	Supply port: 1/8NPT (Special nozzle/cap) Mounting hole: M6×1	Teflon or UHMW stainless	2.0MPa	There
SV01S	312g φ26.9mm (liquid chamber part) x 105mm	Supply port: 1/8NPT Mounting hole: M6×1 tapped hole	SUS303, Teflon	0.7MPa	There
SV59MS	280g (362g) *() shows when equipped with solenoid valve φ27 mm x 91 mm	Supply port: M5 Mounting hole: M6	Stainless steel, PTFE, FKM, PP	0.7MPa	There
SV91FL	300g φ26.9mm (liquid chamber part) x 105mm	Supply port: 1/8NPT female thread Mounting hole: M6 female thread	Teflon or UHMW stainless steel	0.7MPa	There

01
01	SV91

The spray valve SV91 uses a small amount of micro-pressure air to accurately apply a mist. By adjusting the flow rate of the liquid, adjusting the nozzle air, and then adjusting the air stop time,High precision spray control without scatteringcan be done. Adjustable nozzle air discharges after the application cycle is complete to prevent fluid clogging. This greatly reduces maintenance and downtime.

No overspray or splashing
Adjustable fluid flow rate

Related Solutions

Medical/Bio/Cosmetics

02	Valve for substrate coating that can control high viscosity materials with less scattering.
02	SV01S

The coating spray valve SV01S is capable of spraying high viscosity liquids up to approximately 30,000mPa・s. High viscosity materials such as silicone, UV, and grease, which have been difficult to prevent scattering, can be widely applied without contact.

Spray control is possible even for high viscosity materials up to 30,000mPa・s
Compatible with high viscosity liquids such as silicone, UV materials, epoxy, and grease.
Achieves high-precision non-contact spray application with reduced scattering
Establishes easy atomization adjustment and high reproducibility when used with controller SVC620S

03
03	SV59MS

The SV59MS spray valve for ultra-fine coatings uses a small diameter nozzle to enable non-contact, thin-film spray coating. Excellent liquid drainage properties reduce scattering.
Stable thin film spray coating is possible even in narrow spaces.

Non-contact/thin film spray application
Small diameter nozzle can be used
Excellent liquid drainage thanks to the liquid stopping mechanism inside the nozzle
Possible to apply with less scattering

04	High-performance spray valve that enables narrow FineLine application even at low speeds.
04	SV91FL

Fine Line Spray SV91FL uses a specially designed mechanism to enable line application with a width of approximately 1 mm using non-contact spraying. This is a valve head unit that is set up so that it can achieve narrow spray even in the low speed range, which was difficult with conventional models.

Fine line spray coating with a width of about 1 mm is possible.
Thin line coating is possible even when the coating robot moves at low speed.
Enables spray application of low viscosity liquids with reduced scattering.
Easy to change coating width due to compatibility with conventional valve parts