back

Precision valve systems – low maintenance, rugged and reliable

SV Series Valves

SV01 series Coating Valve

Precise coating for high viscosity materials without over spraying

In addition to capability of conventional pneumatic spray valve technology, SV01 series Coating Valve enables to apply higher viscosity materials especially in beading application requiring a certain width. There are two types. "S version" can be used for high-viscosity materials as high as 30,000 mPa · s and "CS type" is likely suited for materials up to 10,000 mPa · s.

        
Part number Application Applied viscosityMaterial
SV01Sgeneral Max. 30,000mPa(s) UV type ◯
RTV◯
Emulsion◯
Modified silicon△
SV01CSelectronics Max. 10,000mPa(s) UV type◯
RTV◯
Emulsion◯
Solvent×

S version(SV01S) <Features>

Ideally applied for higher viscosity materials such as silicon, UV adhesive, or grease

<Features>

Used for spraying higher viscosity material
・Suited for materials with viscosity as high as 30,000 mPa · s.
・Controlled spraying without splattering

S version(SV01S) <Features>

CS version (SV01CS)

<Features>

Designed specifically for conformal coating
・Area coating
・Applied for medium and high viscosity non-solvent coating materials
Used for spraying higher viscosity material
・High-speed coating with a width of approximately 10 mm
・Controlled spraying without splattering

No masking required!

CS version (SV01CS)

Spray valve Controller SVC620S

SVC620S, specifically used with SET spray valve, allows easy setting of nozzle air pressure and the delay for ON / OFF timing. Delay control function eliminates coating variability caused by fluid accumulation, which ensures superior productivity in process.

  • Faster response time
  • Consistent, precise spray control
  • Nozzle air delay function allows for clean cutoffs
svc620s






  • movies

© 2023 SAN-EI TECH Ltd. All Rights Reserved.